NETCTL(1)

NAME
netctl - Control the netctl network profile manager

SYNOPSIS

netctl {COMMAND} [PROFILE]

netctl [--help | --version]

DESCRIPTION

netctl may be used to introspect and control the state of the systemd services for the network profile manager.

OPTIONS

The following commands are understood:

list
    List all available profiles. Active profiles will be marked with a ‘*’.

store
    Saves which profiles are currently active.

restore
    Loads the profiles that were active during the last invocation of ‘store’.

stop-all
    Stops all active network profiles.

start [PROFILE]
    Start the network profile specified on the command line.

stop [PROFILE]
    Stop the network profile specified on the command line.

restart [PROFILE]
    Restart the network profile specified on the command line. If it is not started yet, it will be started.

switch-to [PROFILE]
    Starts the network profile specified on the command line after stopping all profiles that refer to the same interface.

status [PROFILE]
    Show terse runtime status information about a profile, followed by its most recent log data from the journal.

enable [PROFILE]
    Enable the systemd unit for the profile specified. This will create a unit configuration file. If the file already exists, the command fails. No other profiles than the one specified will be enabled. Changes to the general options in a profile specification will not propagate to the unit configuration file automatically. After such changes, it is necessary to ‘reenable’ the profile.

disable [PROFILE]
    Disable the systemd unit for the profile specified. This will remove the file created by ‘enable’ even if it was customized, so be careful.

reenable [PROFILE]
    Reenable the systemd unit for the profile specified. This is effectively a combination of ‘disable’ and ‘enable’.

is-enabled [PROFILE]
    Check whether the systemd unit for the specified profile is enabled. Prints the current enable status.

edit [PROFILE]
    Open the file of the specified profile in an editor. This does not reenable or restart any profiles.

EXIT STATUS

On success 0 is returned, a non-zero failure code otherwise.

ENVIRONMENT

$NETCTL_DEBUG
    If set to "yes", debugging output is generated. The value of this variable is independent of the value of the variable with the same name in profiles.

$NETCTL_STATE_FILE
    The location of the state file. Defaults to /var/lib/netctl/netctl.state.

SEE ALSO

netctl-auto(1), netctl.profile(5), netctl.special(7), systemctl(1)